Retrofit design says you should insulate lead flashing when starting the system just above that flashing. EWI systems start at that point, so the start of the base rail. Insulating flashing is not part of the EWI system, they state that would be the detail and design of the roof not the EWI system. If we do not insulate this section, would this be a ‘fail’ under PAS 2035 or how would this work?

Share:
Share:

Leave a Reply

T: 0330 055 7629
E: info@retrofitacademy.org
A: Barn 4, Dunston Business Village,
Stafford Road, Stafford, ST18 9AB

Terms & Conditions 
Policies & Procedures

Copyright © 2022 The Retrofit Academy. All rights reserved

Website by